| |
Product Description
FX Zing is an interior, water based, tintable, sparkle finish. FX Zing is a hardwearing
and washable liquid paste, especially manufactured for producing a variety of creative
finishes with sponge, brush, roller or spray.
Surface Preparation
All surfaces must be thoroughly cleaned and free of all loose dirt, dust, grease, loose or
flaking paint, and loose surface plaster. Efflorescence or mould on masonry or concrete
surfaces must be treated. Flatten gloss surfaces by thoroughly sanding and wipe clean
with a damp cloth. Then apply FX Primer sealer undercoat as required. Best results are achieved when surfaces are properly prepared and smooth.
Application
Stir contents thoroughly before and during use with a broad flat stirrer using an upward
action. Brush/Roller: Tint base coat as close as possible to the chosen FX Zing colour.
A satin acrylic base coat makes application easier. Apply the first coat by roller.
Ensure the roller is very soft and between 12mm & 18mm. The second coat may be
applied by roller or a 100mm brush using a criss-cross motion. It is important to keep a
wet edge at all times. To slow down the drying time for large or complicated areas add
approximately 10% of FX Scumble.
Conventional Spray: Suitable for application by all standard spray equipment. Ensure
the first coat is completely dry before adding next application.
Requires: 2 to 3 coats of Zing.
Approximate Spreading Rate: 14-16 square metres per litre, depending on application
and surface roughness.
Approximate Film thickness: Wet-70 microns. Dry-25 microns
Thinner: not required
Method: sponge, spatula, special rollers, brush, roller, conventional spray.
Drying Times:(at 25c) Touch: 4 Hours. Recoat: 24 hours. Clean up: Water.
Features
Water based
Attractive finish
Washable
Tintable
|
|
