1

Sealer

Undercoat

FX Australia® Product Information

FX Penetrating Sealer

(Interior & Exterior Only)

Application

Stir contents thoroughly before and during use with a broad, flat stirrer, using an upward action.

Brush/Roller:

Product may be applied with a 100 mm brush or 20 mm roller.

Airless/Conventional Spray:

Suitable for application using all standard spray equipment.

Approximate Spreading Rate:

12-14 square metres per litre, depending on application technique and surface roughness.

Approximate Film Thickness per coat:

Wet: 40 Microns; Dry: 10 Microns.

Requires:

1-2 coats.

Thinner:

Not required.

Tinting:

N/A

Method:

Brush, roller or airless spray equipment.

Drying Times (at 25 °C): Touch: (at 25 °C): Touch: 2 Hour; Recoat: 6 Hours.

Clean-up: Water. Safety: Dust Mask. Gloss Level: Not applicable.

Note: Do not apply paint if the air temperature or substrate temperature is below 10 °C or above 35 °C. The temperature should not fall below 10 °C during the drying process.

Safety and environmental care

Safety

Personal Protection:

Wear eye protection and dust mask when spraying, as splashes may cause eye irritation and inhalation of spray mist may cause respiratory irritation.

Asbestos cement sheeting:

Do not disturb, sand or scrub, and avoid any peripheral dust. If you do not have professional expertise in the handling/removal of asbestos sheeting, use a licensed asbestos removalist.

Refer to product labels, current FX Australia Safety Data Sheets or call FX Australia for detailed information.

Clean-up

Slippery when spilled·

Restrict access to area until clean-up is completed · When cleaning up spills, use personal protection equipment · Stop leak if safe to do so and contain spill with absorbent material such as sand, vermiculite or other inert material · Prevent spill from entering waterways · Collect and dispose of spilled material according to local regulations · Wash away remnants with liberal amounts of cold water.

Storage

Store in a cool, dry, well-ventilated place out of direct sunlight · Store away from strong acids and moisture · Keep containers closed at all times and check regularly for spills.

Disposal

Refer to State/Territory Land Waste Management Authority: most authorities permit disposal at approved land waste sites.

Date of Issue: March 2014

About Us

Australian manufacturer of premium quality speciality paints, architectural & protective coatings and a range of innovative joint & topping compounds.


FX Australia is proudly Australian-owned and Australian-made. We’ve created unique, award-winning paint and plaster finishes for local and international top-drawer brands and design teams and turned many a professional’s concept into reality.

 

Read More

 

We'd love to
hear from you.

© 2018 by NF Designs & FX Australia. Proudly created with Wix.com